 |
Band Tool- BT
After choosing a proper band, determine which
of the posts on the Banding tool most fits the shank and mortise
of the pipe. Heat the band with a propane torch, being careful
not to burn wood, then press the shank on to the selected
spindle pushing the band up on to the shank. When you are
satisfied as to the fit and placement of the band, then place
the banded shank into the circular cavity of the banding tool
and rotate vigorously. This will give a nice even finish to
the band.
$40.00 |
 |
Tenon Cutter Tip- T
TIP
$4.30 |
 |
Tap Set - Taps
Sizes to fit T 9, T 10, T 12 and Meerschaum fittings.
$75.00
|
 |
Tenon Expander: TN
EXP
(Three sizes-in-one: 1/25, 1/50, 1/60)
An absolute must for pipe repair! One tool that will do 99
percent of all loose tenons. Throw away that ice pick because
this will do a much better job. Heat the Tenon with an alcohol
lamp until it is soft. Insert the Expander to the next size.
Place Tenon and Expander into cold water to set the Tenon
to its new size. Remove the Expander and your Tenon will maintain
its new size. .
$29.00 each
|
 |
Tenon Cutter- TC
With floating pin guide, adjustable, two sets of sealed roller
ball bearings, belt driven and six-sided triangle carbon tip.
The unit is a precision made machine with all parts handfitted.
Adjustment of the cutter is by means of a knurled knob to
set the depth of cut to fit the desired stem tenon diameter
to the pipe. Once the adjustment is set, the tenon is lathe
cut in a matter of seconds.
No longer carry |
